DIO and CLK pads on XIAO nRF52840

[PJ_Glasso]

Hi there,
I think it’s the same as this one we checked out ? YMMV
Something similar I’ll bet is possible or use the PLUS varriant also?

Xiao Esp32-s3 JTag pins as GPIO

Hi there , Ok so It works no issue’s Led lights every time through the loop the Built-in on io21 and and external connected thru a 220 ohm resistor to 3.3v connected to the bottom pin io42 the Serial output is the touch pin value (typical 24-29) touched over 1000. Here is the code I used. const int touch_pin = A5; int LED_pin = 21; int MTMS_pin = 42; void setup(void) { Serial.begin(9600); delay (1000); // declaring LED pin as output pinMode(LED_pin, OUTPUT); pinMode(MTMS_pin, OUTPUT…

HTH

GL PJ