Page 1 of 1

Transparent transmission application

Posted: Fri Nov 30, 2018 6:34 pm
by ari.naukkarinen
Hello
I defined Transparent transmission application in automatic working mode (cmd=AT+ATRM=0,0,192.168.1.100,1000) and saved values to flash, how can I exit from this mode

Re: Transparent transmission application

Posted: Sat Dec 01, 2018 4:33 am
by tarp.andreas
hello
you should use the escape sequence! I think it was AT+] and then you are in cmd mode again,
maybe to send a factory reset AT+RSTF

Re: Transparent transmission application

Posted: Tue Oct 01, 2019 7:19 pm
by mailit.ryan
Its not working for me!!
Isn't the escape sequence AT+& or 1B(in hex format) ?
When 1B is sent in hex format it enters the second boot mode. But i was not able to enter the at command mode ?