Transparent transmission application

Have a question about Air602 WiFi Module? Ask here!

Moderators: lily.li, violet, qi.liao, jellyfish

Post Reply
ari.naukkarinen
Pre-kindergarten
Pre-kindergarten
Posts: 2
Joined: Mon Jun 04, 2018 9:18 pm

Transparent transmission application

Post by ari.naukkarinen » Fri Nov 30, 2018 6:34 pm

Hello
I defined Transparent transmission application in automatic working mode (cmd=AT+ATRM=0,0,192.168.1.100,1000) and saved values to flash, how can I exit from this mode

tarp.andreas
Pre-kindergarten
Pre-kindergarten
Posts: 4
Joined: Mon Mar 26, 2018 7:06 pm

Re: Transparent transmission application

Post by tarp.andreas » Sat Dec 01, 2018 4:33 am

hello
you should use the escape sequence! I think it was AT+] and then you are in cmd mode again,
maybe to send a factory reset AT+RSTF

mailit.ryan
Pre-kindergarten
Pre-kindergarten
Posts: 3
Joined: Mon Sep 30, 2019 3:04 pm

Re: Transparent transmission application

Post by mailit.ryan » Tue Oct 01, 2019 7:19 pm

Its not working for me!!
Isn't the escape sequence AT+& or 1B(in hex format) ?
When 1B is sent in hex format it enters the second boot mode. But i was not able to enter the at command mode ?

Post Reply