Seeed XIAO BLE Sense LSM6DS3TR-C INT1 and INT2

[Michael1]

Are INT1 und INT2 of the LSM6DS3TR-C connected to the nRF52840?
Is it possible to provide a circuit diagram of the Seeed XIAO BLE Sense?

Thank you in advance
Regards
Michael

[wwbrown]

INT1 is connected to P0.11, the schematic shows that as the only INT connected which is a shame because there are some unused pins on the MCU.

Did you get the accelerometer to work? I tried the examples identified in the wiki page for the board and it hung.

[Michael1]

Yes, I found a solution here:

XIAO BLE SENSE cannot communicate with IMU sensor

Hello community, I have just received two XIAO BLE SENSE boards and try to run the IMU examples. However, I am not able to properly initialize the sensor and read actual values. I have followed the example from the wiki, programming via the latest Arduino IDE (after installing the board support package, confirming blink to work and installing the library for the IMU sensor) and have also tried the CircuitPython example on using the IMU as per the posing on this forum. IMU.begin() fails with er…