Hello Everyone,
I hope this message finds you well. I’m experiencing a peculiar issue with my ESP32C3 board and the 24GHz mmWave Human Static Presence Module Lite. I’ve successfully followed the tutorial found here: XIAO ESP32C3 accesses Home Assistant via ESPHome service | Seeed Studio Wiki, and it has been working flawlessly for days. However, I’ve run into a problem when trying to adjust the “presence_maximum_detectable_range_of_stationary_target” parameter.
Whenever I change the “presence_maximum_detectable_range_of_stationary_target” value, the Presence Module stops working entirely, and no matter what I do, I can’t seem to get it working again. It’s quite frustrating. The only solution that has worked for me is replacing the Presence Module with a new one, and then it functions as expected until I make any changes to the parameter again.
I’m not sure what I might be doing wrong, and I’m seeking some guidance or assistance to resolve this issue. Has anyone else encountered a similar problem or could offer some insights into why this happens and how I can address it?
I would greatly appreciate any help or advice from the community or the support team regarding this matter. If you have any suggestions, recommendations, or if you need more details about my setup to better understand the issue, please let me know.
Thank you in advance for your assistance.
Best regards,
Miguel.