Propaganda board sizes

[matseng]

In the dox is says that the max size for a propaganda board is 10 by 10 cm. This would then make my 3 by 16 cm board not "propgandable". :(

I think that restricting the boards size to max 100 cm2 would be better than limiting the size to 10 cm in any direction.

Is this limitation a matter of ease of panelization?

/mats

[rev0]

I had the same question. My board is literally millimeters over the 5cm x 5cm limit so I would have to move up to the 10cm bracket unless I can shrink my board down (it's already pretty darn compact so I'd rather not). How rigid are these limits?

[Albert.Miao]

Hi guys,
Yes, the size is not suitable for many projects.
But it is generate by our PCB factory, we must obey it.
And the square PCB is easy to panelize...
Thanks
Albert

[john p593]

I suggest that the information on the website should make this clearer. I was wondering too--I've been thinking of a board 2in x 5in, which is less than 100 sqcm, but it wouldn't be acceptable.

You could say: "Board must fit within a 10cm square" or "Longest dimension must not exceed 10cm" or something like that.

And are there restrictions on board shape? Cutouts etc?