Page 1 of 1

Question About CENG AT Command on a Lonet SIM808.

Posted: Fri Mar 30, 2018 1:38 am
by oscar.llerena.c
Hi everyone

I have a Lonet SIM808 GPRS Module which I can control through AT Commands interface provided by Arduino Mega 2560 serial monitor terminal.
The AT Command: <AT+CENG?> issues the following line:

+CENG: 0,"0240,35,00,716,10,15,2010,08,00,047e,255"

I am looking for the Receive Power Level which according to this:
https://www.elecrow.com/download/SIM800 ... _V1.09.pdf it is 35. But 35 is not a recognizable value ... somebody know the value translate for this values?

Re: Question About CENG AT Command on a Lonet SIM808.

Posted: Fri Aug 10, 2018 11:51 am
by hong.jiang
Hi:
How did you get 35? Which AT Command did you use? Taking a screenshot may be more clear and intuitive.