RFBee firmware updating

[Icing]

Hi there,

Thanks for your updating!

Hans,

@Icing: should we extend rfbee sleep mode to letting the atmega sleep as well ?
We could define a ATSL to define sleepmode. E.g.
0- WOR for CCX, IDLE for at168 (radio reception will work, serial will still work)
1- WOR for CCx, STANDBY for at168 (radio reception will work,serial will take some time to wakeup)
2- SLEEP for CCx, SLEEP_MODE_PWR_DOWN for at168 (lowest power consumption, but longest wakeup time, WOR will not work)

That will be very good, which I was always wanting to do. And thanks for your valuable link

ps. “without a hitch” means “without a problem”

This is much easier to understand to me

Rich,

I did not do the test, but I guess I may encounter the same question as you. I think Hans is right, especially the size of CCx_PACKT_LEN may have some influence which I ignored on the datasheet.

So we should be fine to ignore the CCX_RXBYTES and just read the packet from the queue. Simplifies the code (less bytes ), and avoids false positives for errors which don’t seem to be errors. What do you think ?

Maybe we could have a try, though it seems not much reassuring.

Again, Thank you so much!

-Icing