Hi,
Sorry for the late response, and we’re truly sorry to hear about your experience. We completely understand your expectations, especially if you’ve been working with the original Jetson board.
However, the key difference is the Seeed reComputer uses different carrier board rather than the Nvidia official one. In that case, you should follow our wiki instructions to flash a system into SD card. We realize this may have caused confusion, and we sincerely apologize if this led to any inconvenience or a sense of being misled.
To help resolve this, we’ve provided a detailed guide on our official Wiki which explains the correct flashing steps for our device:
Enable SD Card: J101 Enable SD Card | Seeed Studio Wiki
Boot from SD Card: J1010 Boot From SD Card | Seeed Studio Wiki
Thank you again for your understanding.
Regards,
John