Issues Launching Wio LTE Cat M1/NB-IoT Tracker in Bootloader Mode

Simplify IoT Development.

Moderators: lily.li, violet, seth.welday

Post Reply
ian183
Pre-kindergarten
Pre-kindergarten
Posts: 1
Joined: Thu Aug 29, 2019 3:52 am

Issues Launching Wio LTE Cat M1/NB-IoT Tracker in Bootloader Mode

Post by ian183 » Thu Aug 29, 2019 10:32 pm

I recently received a Wio LTE Cat M1/NB-IoT Tracker and have done a few code uploads to the board without issue.

I have since updated my code and would like to deploy it to the board, but I'm now unable to get the board into Bootloader mode using the standard procedure (Hold BOOT0, hit RST, release RST, release BOOT0). Standard RESET works to restart the board, but I just cannot get Bootloader mode going.

Is there another way to force Bootloader mode? If not, is there a way to do a full reset of the board to the factory state?

Thanks for your help!

bill.yu
Junior-7
Junior-7
Posts: 735
Joined: Mon Apr 02, 2018 11:05 am

Re: Issues Launching Wio LTE Cat M1/NB-IoT Tracker in Bootloader Mode

Post by bill.yu » Fri Aug 30, 2019 2:18 pm

Hi there~

Please press and hold BOOT button at back side of the Wio LTE Cat NB1 and plug the USB to PC. It shall be able to enter bootloader mode. Hope it helps. thanks.

Post Reply