Hi
Has anyone successfully used the UART USB connector on the Grove Sensor Mezzanine board for 96 boards platforms? I have tried on two different boards without success:
Ultra96 V1 - get output but can't input anything
IMX7-96 - get nothing
I note that this sensor board was tested on the Qualcomm Dragonboard 410c and the LeMaker HiKey boards. Does anyone know if any changes were needed to the U-boot configurations or devicetree in order for the UART to work for these platforms? That might give me some clues!
Thanks in advance
Simon
Grove Sensor Mezzanine for 96 Boards UART
Moderators: lily.li, violet, salmanfarisvp, jeremy882, crail.lyu969
-
- Pre-kindergarten
- Posts: 1
- Joined: Tue Jul 09, 2019 3:14 pm
Re: Grove Sensor Mezzanine for 96 Boards UART
Hi Simon~
I see you posted the question on 96boards and they are right person to ask
thanks.
https://discuss.96boards.org/t/grove-se ... ction/8353
I see you posted the question on 96boards and they are right person to ask

https://discuss.96boards.org/t/grove-se ... ction/8353