Draw my own Binary Bitmap with oLED

Grove is a modulated, ready-to-use tool set.
Much like Lego, it takes a building block approach to assembling electronics.

Moderators: lily.li, violet, jeremy882, crail.lyu969

Post Reply
zws
Pre-kindergarten
Pre-kindergarten
Posts: 28
Joined: Mon May 02, 2011 3:15 am
Are you a staff member of seeedstudio?: no
Which products/projects are your favorite?: aham

Draw my own Binary Bitmap with oLED

Post by zws » Sun Jan 15, 2012 6:54 am

Hey there,

Anyone willing to lend a hand? I am trying to create and upload my own hex image to the oLEd without any success!

How did you guys at SeeedStudio managed to create your logo? (see: http://www.seeedstudio.com/wiki/index.p ... OLED_96x96)

I followed ladyada's advice that you can find here (http://ladyada.net/products/oled12864/) with no luck! :(


Thank you so much in advance for your help!
zws

viswa
Staff
Staff
Posts: 168
Joined: Tue Jan 25, 2011 11:16 am
Are you a staff member of seeedstudio?: no
Which products/projects are your favorite?: Seeeduino Film,Motion Frame,UartSbee

Re: Draw my own Binary Bitmap with oLED

Post by viswa » Mon Jan 16, 2012 6:18 pm

Hi,

You could use http://en.radzio.dxp.pl/bitmap_converter/ tool to create the bitmap array. Please make sure you use a binary image(2 level image) and scaled to 96x96 pixels size. Use an image editor software like GIMP to edit or scale the image. If you still face some issue, give details about the problem you face.

I hope you were able to compile and upload Draw Binary Bitmap example from the above wiki.

schmron
Elementary-1
Elementary-1
Posts: 145
Joined: Mon Dec 05, 2011 6:12 am

Re: Draw my own Binary Bitmap with oLED

Post by schmron » Tue Jan 17, 2012 10:01 am

Best regards from Vienna/Austria
Rony

Post Reply