Ethernet shield constant reset status

[mikeder]

@marco.canali

The same happen to me, with the Seeed Ethernet Shield V2.0 every time the power goes down i need to ‘MANUALLY’ reset the shield or the arduino, because if i do not the Seeed Ethernet Shield stay on Orange light on the RJ45 and NOT communication are possible! I try with the software reset to go LOW with a Pin connected to the reset Pin but it DID NOT work for go UP the Seeed Ethernet Shield …

This is a big issue if you want to use the shield in remote condition !!

I’m waiting an answer from Seeed Studio Team !! I have many of these shields and that issue make them usless !!

Thanks

Hello marco

Did you find a solution to your issue. I am having the same issues. I did notice that if i start a serial monitor after appling power the ethernet will start. It seems like it waits for the serial port to respond.