Page 1 of 1

Approving DRC errors okay?

Posted: Sat Nov 03, 2012 12:09 am
by jeremy.xiao725
In Eagle I have traces from two different net classes that I want to connect. I've tried simply connecting the traces, and I've tried using a solder jumper part. In both cases, the project fails the DRC check because the components are too close to one another. Of course, this is okay with me. They're supposed to be close (overlapping!). Can I just approve this DRC error, create the gerber files, and send them off?

Thanks,
Jeremy

Re: Approving DRC errors okay?

Posted: Wed Nov 07, 2012 9:22 am
by dingding
yes, you can ingore it.
i suggest you can set the clearance of same signals as 0mil in DRC rule, the errors will be disappeared.
have a nice day!
dingding

Re: Approving DRC errors okay?

Posted: Fri Dec 28, 2018 3:03 pm
by catherine12297
indeed, you can ingore it.
I recommend you can set the leeway of same flags as 0mil in DRC rule, the blunders will be vanished.
have a pleasant day!
dingding