Page 4 of 4

Re: DSO Nano V3 purple Data trace & saving files?

Posted: Sun Jul 21, 2013 9:27 pm
by gratefulfrog
Did you try to connect to a Linux PC? Did you read the firmware upgrade page on this forum?

Even with the original firmware I could put files on the nano.

I'm happy TT o try to help, but please try to explain better we what you did and on what PC... Etc

Ciao,
Bob

Re: DSO Nano V3 purple Data trace & saving files?

Posted: Fri Aug 16, 2013 6:35 pm
by g4vvq
to get rid of purple sinewave, hightlight EX press left arrow until it says Off, press top right key to save commands, hold it in then press again to save it, bottom M key save files.


Hi There...you have 3 options, whatever will work

1 benf program
2 copy the 2 hex files
3 use original prog, see my other messages for info, ver 4.22 at moment.

G4VVQ Fred
gratefulfrog wrote:Hi,

I just got a DSO NANO V3 with all factory setup and firmware. I don't know how to tell which firmware it is...

I think the little device is pretty cool and value for money, but I have a couple of issues that I can't seem to work out from the so-called "manual".

Could anyone please tell me:
  • how to get rid of the purple DATA trace (looks like a decaying sin wave) ?
  • how to save and load data, images, i.e. how to record a trace to memory?
  • where to get other firmware that may work better than what is on board?
Thanks for your help.
Ciao,
Bob