Page 1 of 1

Harness for the Nano?

Posted: Sun Aug 23, 2009 7:25 pm
by omlan

I know this is just stupid, probably a waste of time.
if you want to read on you are welcome.

Well some people in the arduino world like ALOT OF SPACE on the breadboard, so they use a Arduino Nano. I was thinking
maybe you guys could build an Harness ( I will make a rough one and provide PICture) for the Nano where you put it into
female headerpins and it like splits into more female header pins, and on the top perhaps a Mini breadboard for the small projects
and on the side a Half size 400point breadboard?

Omlan Azad

Re: Harness for the Nano?

Posted: Mon Oct 26, 2009 10:42 am
by admin
Good point, how about using proto shield as an alternative? :)