11-pin connector power

Xadow series products.

Moderators: violet, jessie, nosk

Post Reply
desperal
Pre-kindergarten
Pre-kindergarten
Posts: 1
Joined: Wed Mar 30, 2016 2:50 am

11-pin connector power

Post by desperal » Wed Mar 30, 2016 3:09 am

Good day everyone!
I try to power up Xadow Duino by GSM+BLE board over 11-pin xadow bus. And failed. Maybe i'm not good in plugging little stripes in tight places..
When I try to place bus in socket deeper I short Vbat pin to GND :(
maybe it's not a good idea - to place GND and power in the neighboring contacts.
GSM+BLE xadow socket is fried now, but board looks good.
finally my question: How to connect modules properly? Hi-res photo, manual or good advice.

Post Reply