Page 1 of 1

How to change mode on xadow NFC?

Posted: Tue Dec 15, 2015 6:45 pm
by carlos.gomez
Hi,
I am using the Intel Edison with the Xadow NFC v1.0, all the info i found on the web(also from wiki) about this module says that the module supports 3 modes (I2C, SPI, UART) but i dont know how to change this option. I expected that the module got some kind of micro switch or similar but I didn't saw it.

How can I change the mode of the module?
or the mode is chosen from my code?

Thank you for any help you can give me.

Re: How to change mode on xadow NFC?

Posted: Tue Dec 22, 2015 5:41 pm
by kavi
Hi,

You can change the mode through code.

Note: When Xadow NFC is using SPI communication protocols, there is an existing library which supports phone-to-Xadow NFC communication. The default communication mode for this product is I2C, so the library cannot be used directly.

Thanks and Regards