Page 1 of 1

Made a new sketch

Posted: Mon May 13, 2019 11:41 pm
by nongvaicut
Hi all,
I'm new here and currently working with Arduino and a CAN-BUS shield. Idea is to simulate some (CAN) signals from missing modules to make a car working correctly (missing speed signal, etc).

I made a new sketch to check if all is working.
Thanks

Re: Made a new sketch

Posted: Sat May 25, 2019 1:58 am
by briangglowe
nongvaicut wrote:
Mon May 13, 2019 11:41 pm
Hi all,
I'm new here and currently working with Arduino and a CAN-BUS shield. Idea is to simulate some (CAN) signals from missing modules to make a car working correctly (missing speed signal, etc).

I made a new sketch to check if all is working.
Thanks
Great work. Keep up the good work and thanks for sharing the idea, now i am gonna do the same.

Thanks and Regards,
Lowe