Page 1 of 1

Grove Sensor Mezzanine for 96 Boards UART

Posted: Wed Jul 10, 2019 2:01 am
by simon.goda
Hi

Has anyone successfully used the UART USB connector on the Grove Sensor Mezzanine board for 96 boards platforms? I have tried on two different boards without success:

Ultra96 V1 - get output but can't input anything
IMX7-96 - get nothing

I note that this sensor board was tested on the Qualcomm Dragonboard 410c and the LeMaker HiKey boards. Does anyone know if any changes were needed to the U-boot configurations or devicetree in order for the UART to work for these platforms? That might give me some clues!

Thanks in advance
Simon

Re: Grove Sensor Mezzanine for 96 Boards UART

Posted: Wed Jul 10, 2019 9:50 am
by bill.yu
Hi Simon~

I see you posted the question on 96boards and they are right person to ask :-) thanks.

https://discuss.96boards.org/t/grove-se ... ction/8353