Infrared Temperature Sensor

Grove is a modulated, ready-to-use tool set.
Much like Lego, it takes a building block approach to assembling electronics.

Moderators:, violet, jeremy882, crail.lyu969

Post Reply
Posts: 1
Joined: Fri Feb 10, 2012 9:32 pm
Are you a staff member of seeedstudio?: no
Which products/projects are your favorite?: smart phone system

Infrared Temperature Sensor

Post by hinman » Fri Feb 10, 2012 9:42 pm

I have bought the infrared temperature sensor, below type. ... ure_sensor
But I don't know which pin is VCC, GND, OBJ and SUR
if i want to connect with computer to test it, just like the wiki page,i alreadly download the source code in wiki page, what device we need to use for testing?
Is that using a serial monitor, connect to Com pin in computer? If yes, any other things need?
thank you

Posts: 145
Joined: Mon Dec 05, 2011 6:12 am

Re: Infrared Temperature Sensor

Post by schmron » Sat Feb 11, 2012 7:54 am

Its a analog sensor, so you need a AD converter for measuring. You need a microcontroller with serial interface for a connection to pc. The sourcecode from wiki is for use with a Arduino Uno compatible Board (Seeeduino) and a Grove Base Shield. Connect the sensor to analog pin 0 on your Base Shield.

Seeeduino: ... th=132_133

Grove Base Shield: ... th=132_134

Cable: ... th=178_179
Best regards from Vienna/Austria

Post Reply