Page 1 of 1

Seeeduino Lotus error when uploading

Posted: Wed Jan 23, 2019 6:31 am
by r0b0tn1k
I have a new PC and I cannot get the Seeeduino Lotus to work. It worked fine on my last pc.

I installed the drivers, and when I try to upload, I get error:
No device found on cu.SLAB_USBtoUART
An error occurred while uploading the sketch

I have selected Seeeduino Lotus - Cortex - M0+ as the board.

Port is /dev/cu.SLAB_USBtoUART

Programer is AVR ISP.

It does not allow me to select baud rate or other information, I only have Board and Port for this board.

I tried uploading to NodeMCU and that works, so the driver is ok.

Please advise.

Re: Seeeduino Lotus error when uploading

Posted: Thu Jan 24, 2019 2:29 pm
by bill.yu
Hi there,

Seeeduino Lotus 1.0 works at Windows Operating System ONLY. Seeeduino Lotus 1.1 works with Window and Mac.

which version do you have? thanks

Re: Seeeduino Lotus error when uploading

Posted: Fri Jan 25, 2019 8:49 pm
by r0b0tn1k
Hi, I have 1.1 version. I can provide photo for proof if needed.