Facing problem in MH-Z16 CO2 sensor with Arduino Board

Hello,

I have bought this MH-Z16 CO2 sensor and now I have problems to receive data from the sensor, I have connected this sensor with Arduino MEGA board with shield(UART/I2C).

I have run the code from http://wiki.seeedstudio.com/Grove-CO2_Sensor/ and get the output but all the 9 values get the same output at a time, there will be no change and after refreshing the serial monitor output I get the another result but all are same.



I have attached the output page below.



Please help me out from this problem as soon as possible.
NDIR_OUTPUT.png

Hi there,



Please refer to viewtopic.php?f=17&t=8208&p=27759&hilit … 2d8#p27759 thanks.

Hi! Did you find a solution to your problem? I bought this sensor and i have the same problem as you.

Yes, I am facing the same problem, too. @bill.yu can you send us the link to the solution? The link no longer works.
Thanks.